NORDIK HVLS HYPERBLADE 700/280" T SVT

• Nominal diameter of 700 cm.
• Thermally protected EC (brushless) motor, three-phase power supply (200-480 V / 50-60 Hz), capable of delivering greater performance than its counterpart with the same diameter.
• Aerodynamically profiled anodized aluminum blades, equipped with winglets that reduce drag induced by wingtip vortices.
• Control electronics for power management and operational control, complete with EMI/EMC filters to prevent the risk of possible electromagnetic interference, housed in the aluminum casting of the motor covers. The electronics include:
• an isolated RS485 Modbus communication bus, which allows the fan to be integrated into a BMS,
• an isolated analog input for speed adjustment via an external potentiometer (optional) or other device operating with a 0-10 V signal.
• Integrated electronics safety system includes protection against overcurrents, short circuits, overtemperatures, overvoltages, and undervoltages. In compliance with NFPA 72 (National Fire Protection Agency) requirements, the fan control system forces the fan to shut down and immediately lock out upon receiving a water flow signal from the fire alarm system, thus avoiding compromising the effectiveness of any installed sprinklers.
• A sheet steel kit for ceiling installation includes a support pole (nominal length 1.5 m), a pair of brackets, and the relevant metal hardware, supplied as standard. This kit ensures the device is securely and securely attached to the ceiling in the most common installation methods.
• Optional kit consisting of 4 tie rods, specifically designed to ensure additional axial stability. This kit is mandatory if the fan installation location:
• exposes it to gusts of wind,
• exposes it to the risk of accidental impact with nearby moving machinery or equipment,
• exposes it to the risk of contact with birds,
• is located in a seismic zone or is otherwise subject to significant vibrations (e.g., industrial processes involving hammers, industrial presses).
• Speed ??can be adjusted via potentiometer or remote control units (VORT T, VORT T-HCS, VORT T PLUS, and VORT MASTER) (optional).
• Motor protection rating IP65.