VORT HR 300 NETI

• Plastic (PPE) enclosure.
• Aesthetic front panel made of plastic resin, glossy finish.
• Round duct connection ports, nominal diameter 125 mm.
• 2 EC (brushless) motors with shaft turning in ball bearings, each coupled to a forward curved centrifugal impeller; 3 speeds, independently adjustable at the installation.
• High-efficiency counter-flow heat exchanger in PS resin.
• Automatic by-pass for free-cooling (manual activation allowed as alternative).
• 1 ePM10 50% (M5) filter on supply air and 1 ISO Coarse 65% (G4) filter on extract air. The filters occlusion status and so the maintenance need is shown on the control panel.
• Control panel, on the front cover, allowing:
• the product configuration at the installation,
• the manual setting of the operating mode,
• the automatic operation settings and the correct functioning monitoring,
• the system diagnostic,
• the constant filters status monitoring and the relative maintenance / replacement needs,
• firmware updates.
• Bracket for wall-mounted installation supplied as standard.
• Passivhaus Certification.